Laser Marking PDF  

 

The Laser Engraving Machines manufacturers by us have the ability to engrave, etch or mark an object
The Laser Engraving Machines manufacturers by us have the ability to engrave, etch or mark an object. The machines utilize computer based techniques to guide the laser rays to achieve precise and clean engravings at a rapid rate on different types of surfaces like make advertising signs, nameplates, badges, seals, bronzing plate, indentation plates, signs, construction models, instrument panels, wooden products, mold products, industrial mould, etc. The technique does not involve tool bits which contact the engraving surface and wear out. It is an advantage over alternative engraving technologies where bit heads have to be replaced regularly.

Application
Deep Engraving Register Trimming
Parts marking on the conveyor lines Logo etching (material vaporization)
Parts identification lot Date & OCR codes
UID Pictures
Complex graphics Surface annealing
Surface texturing Surface marking
Surface etching Serialization
Alphanumeric Part numbers
Schematics Complex graphics
Surface annealing Direct parts marking
2D data matrix codes Lot codes
2D Symbols Linear barcodes
Module Speficition
Type Nd – Yag
Pumping Diode Pumped
Laser power 50w
Laser Pulse Frequency 50KHZ
Wavelenth 1064nm
Beam Quality M2 < 4
Marking Scope (mm) 70*70 110*110 150*150 200*200
Marking Depth 0.3mm
Marking Speed 7000 mm/s
Min Line Width < 2 mm
Min Charaacter 0.25mm
Repeat Accuracy +- 0.001 mm
Cooling Styple Closed Loop Water Cooling
Laser Module Life 10000 hours
Input power <2.5 KW
Power Supply 200V (+-10%) /50Hz Single Phase
Operating Temperature 10’ c – 40’